In the technique of fishing tackle DZ is possible to distinguish several independent elements: casting tooling, casting lines into the working position, the wiring, the abandonment feeding, fish fish.
Apparently, there is no need in detailed description of techniques commonly used when working with a spinning reel. The only thing you should say: when you perform a DZ message snap-in is much smoother, with gradual acceleration, in contrast to the art, for example, used in spinning. This is due to the characteristic design of fishing rods for DZ, which have soft tip and hard bottom part.
With a very sharp message snap-in Konik for some time because of inertia will remain in place, and a more rigid lower part of the rod goes forward. When the critical load of this type the upper part of the rod as if “cuts”. Also the rod can break for another reason: if you throw incorrectly set Swiss tooling. At too great a length of fishing line from the Tulip to the hook at the time of the swing can happen hitting a snap for anglers located behind grass or bushes. In the best case in this situation when sending the snap-in will be open in the worst – breaking the rod tip.
Long Swiss were forced to practiced when fishing on the DMZ with a stationary mounting of the float on the fishing line. When you use a snap with a sliding float with a rod length of 4 m Swiss usually does not exceed 1.5 m. experience shows that short Swiss tooling significantly increases the accuracy of the cast, almost without affecting its range.
Before each throw, you should check whether the fishing line freely passes through rings, because the weakening of its tension, for example, during donning of the nozzle on the hook can lead to obkusyvanie fishing line around the rod tip close to the Tulip, which is also fraught with “tragic” consequences for the entire tooling in General.
As noted above, when executing a cast – to choose the optimal effort and the height of the message snap. This “feeling of flight” comes with experience through training under the guidance of a qualified coach.
When fishing on the DMZ, the angler more than just “annoy” side wind, if he still blows it. Line much “parasit”, creating a great arc on the water which makes it very difficult cutting. Tooling becomes unmanageable, it quickly comes out of the zone of fishing. This negative impact can be greatly reduced.
First, you need to apply very thin and sinking line and heavy enough snap. Second, before landing snap her need to slow down a little to line as straight. At the same time with a touch of water snap the rod tip quickly immersed approximately 0.5 mm under the water and is quick to retrieve a few meters of the line until the complete immersion of all the line lying on the water. This simple technique to bring snap into the operating position significantly improves management in difficult fishing conditions.
The main technical device for fishing tackle DZ is the wiring. She is short and smooth movement of the snap-on area of fishing, with the necessary pauses between them. These manipulations are performed using rod and reel. Quality wiring will only be at tight line: a good connection of the rod with the snap-in allows you to react to the bite. In the course of the transaction is performed with a constant deceleration of the snap-in or with short pauses between short-term slowdown. This is achieved by appealing to “game” the nozzle, inducing the fish to bite.
In accordance with the optimal conditions of catching trajectory wiring, distributed and bait in the area of fishing, with a gradual subsequent concentration of it in that part of the zone, which most frequently occur with bites of fish.
The composition of the applied mixture, as a rule, the standard for this type of fish and conditions. In this case it is only necessary to increase the amount of ballast in it and share binders. It is necessary for a distant (30-40 m) throw ball of bait without its destruction in the air. A common mistake of many novice anglers is that they are throwing hand a ball of groundbait heavily hyping his fingertips. In this case, even a ball of viscous mixture will break by centrifugal forces.
Right to cast the bait long distances, you need to learn. The second common mistake is throwing excessively large balls, then the value of the centrifugal force is directly proportional to the diameter of the rotating body. Optimal ball size no more than chicken eggs. Lately, to ease the casting of bait and to improve the accuracy in the intended place, many anglers have with this goal is to use slingshots special design.
The bite, the sweep, and fish fish is virtually inseparable moments catching equipment. They are the final phase of the efforts of the angler to achieve success at fishing. Typically, the bite is expressed in the disappearance under the water signal of the float or rise in a noticeable antenna. Ultimately, the nature of the bite depends on the type of fish and its activity. Novice anglers often mistaken for bites sadawy the hook at the bottom or exit of the shipping in the shallow waters. With experience that goes.
When the characteristic change of the position of the float must be followed by immediate, but soft sweeps with a small amplitude. When tight line and quality hook that is enough. Strong with a large amplitude sweeps is bad because in the best case leads to the edge of the leash or lip of the fish, which naturally threatens the loss of perhaps enviable trophy. In the worst case may occur breakage of the rod tip.
If the fish was on the hook, then comes the stage of a fight, the character and the rate of which depends on the type and size of prey relative to the capabilities of the entire gear as a whole. In the case of large prey, first, must reliably operate the friction brake on the reel, preventing the critical load to tackle. In this case, is usually used the tactic of “milking” the prey, pulling it with the rod with a subsequent selection of the line coil in the return of the rod tip in the lower operating position (usually 45 degrees to the horizon).
Attempts to pull the big fish only by means of coils usually lead to excessive pulling of the fishing line and its deformation during the passage through the rings. As a rule, in the future this line will have a tendency to the formation of “beard” or “sheep” on it when casting, which in turn will lead to various troubles with a snap. If the prey is small, it wasted no time, vyvazhivaete through the coil, holding the rod so that its bent tip was a continuation of the line.
In this position of the rod and should be in the final stages of a fight to take the fish in the net. From the above it is clear that if the rod length is 4 m, and the angle of inclination to the horizontal when playing a fish usually doesn’t exceed 60 degrees, the length of the net may not be less than 2,5-3 m. Use net required. This allows time to fend off the desperate jerks of large prey close to shore. With a shorter line this fails.
Finally, I would like to say that modern, well-built, balanced tackle to CLE greatly expands the capabilities of the angler, especially on large bodies of water and during the autumn cooling of water. It allows you to get away and usually at a great depth standing careful the big fish. Playing the same solid production at the long and thin fishing line is a great pleasure and memorable experience. Besides, what also attracts to this way of catching more of his fans, on a thin fishing line big fish bite more often than various quite rough and the donkey zakidushki.