When choosing a feeder, it is necessary to proceed from the conditions of fishing. Most often, fishing occurs in reservoirs that have a not too large flow or without it.
The distance of fishing is also small – no more than 50-60 meters, and then on large lakes and reservoirs, where there are few bream-like places near the coast. Usually, fishing occurs 20-40 meters from the shoreline.
Accordingly, the rod should be a standard length for a normal feeder – from 3.3 to 3.9 meters. The traditional feeder rod test is usually medium or medium fast. How fashionable now to say – progressive. The test rod should be in the range of 80 to 120 grams. It is possible to catch even harder rods, if they are made sufficiently qualitatively and have a wide range of weights from 80 grams to their maximum value.
The larger the rod test, the larger the size of the start-up feed can be used and the faster it will be done, saving a lot of time. But the catch itself should take place with a not very large feeder, which will not frighten the flock of bream on the spot.
The coil is used normal for the feeder. For the speed of the winding catch bream special requirements does not impose. On the contrary, low-speed coils are more reliable and durable, and an increase in the gear ratio even by a couple of tenths reduces these figures. Moreover, it is unlikely that you will be able to catch a bream at a high pace, as the flock is shy and doesn’t get to the point not so quickly after catching the fish.
Fishing line is used wicker, especially for fishing on the course. You can catch it with a regular fishing line, but only in standing water and with a small casting distance. Of course, if conditions allow, you can put a regular fishing line 0.2-0.25 mm. The leash is set long, from 0.5 meters, and its cross section should be 0.15-0.2 mm. Too thin leashes should not be used, as the bream can offer resistance, and the grass in places where the bream is caught in June is a lot. The hook is used, suitable to the nozzle, and which corresponds to the size of the fish. Be sure to use swivels for attaching the leash and feeders, which will minimize the entanglement and twisting of the fishing line.
You can often see how anglers use flat feeder and hair accessories for fishing.
Where and when to look for bream in June
Spawning of bream occurs in May. This fish spawns at relatively overgrown places, floodplain meadows and other areas that are medium-grassy with a depth of 0.8-1.5 meters. Usually, bream begins to move to spawning grounds in April from its winter sites. First comes the smallest bream, and then the larger one.
After spawning, the bream has a rest for a couple of weeks, and then the flock begins to actively feed on it.In June even the largest bream moves away from spawning, and since the middle of this month it bites well on the feeder. For spawning, the fish rises to the lake floodplain, to flooded areas on the reservoirs, to small rivers flowing into a large or a lake.
You can catch this fish not far from the places where it spawned. Usually bream is near them for about a month, making transitions during the day in search of food – good, during the beginning of summer there is enough of it on the flood plain, many insects and bugs. However, for catching feeder floodplain is not always suitable. The main reason is grass.
It is advisable to choose a place where the bottom of it is free, or at least the grass does not grow thick thick carpet, not allowing you to find a nozzle and bait. These can be steep slopes, which are washed away at the turn of the river, where many worms and grubs from the ground are brought into it, some equipped banks of reservoirs, beaches near the grass thickets. The second option is to throw it far enough away from the shore, towards the riverbed, throwing a general understanding. Bream can also be found there, but more often it occurs near the grass.
For fishing it is best to choose the dawn dawn, having prepared everything you need at dusk. During the white nights in the northern lands you can catch bream all night long, and very effectively! Perhaps, for those who are not accustomed to get up early, it will be the best option – to go fishing and not go to bed at all, and then get some sleep, catching fish. He bites on the evening dawn, but the evening biting is more characteristic of late summer and autumn. Sometimes you can catch it in the afternoon. But the morning bite is the best, and the chances of catching a large bream are also good.
Lure
She needs a lot to catch bream. The fact is that this fish is a flock, and collects everything that it meets on the bottom. If the feed is over – the flock leaves, and for a long time. To detain her, we must offer her a very good table, which she will destroy for a long time with her stigmas. Apply a large number of bait, both nutritious and with the ground. Here it is important to create a good volume so that the bream can stand and constantly smell the bait, it finds more and more nourishing pieces in the primorochny spot.
In general, when starting zakorm, you have to throw about five liters of bait to a point, and during the long fishing period you may be thrown there as much again. It is clear that not all of the anglers are ready to mix ten liters of clean ready-made bait mixture. Comes to the aid of the primer and the addition of porridge.
Soil goes only to starter zakorm. The task of the starting feed is to create a spot on the bottom, which is somewhat different from the surrounding, on which the bream will find food. Soil from the shore or from the package – this is exactly what will contain some minerals and salts, which include oxygen bubbles that attract attention from a distance, has an unusual, but familiar to bream color and smell. The addition of soil is quite attractive in June. Bream is looking for food in the flooded areas, the water has not slept. He perceives the soil as something on which he was used to finding food for himself already during the spring floods.
Porridge is added to the finished bait in order to increase its nutritional value and volume with a constant amount of the purchased mixture. Additive occurs prikormki in porridge with constant stirring. Of course, porridge must be crumbly and dry enough. After that, when the porridge is sufficiently rarefied with the finished bait, water is added to the mixture, but in much smaller quantities than would be done by mixing the dry mixture. Then, if desired, the mixture is crushed with soil and used for zakorm, or used in this state for fishing with a working feeder. Thus, the amount of dry bait for serious fishing is reduced by five or six times.
The living component should also be in the bait. At this time, it is quite difficult to find cheap moth for sale, even a small one. Maggot as a living component fits poorly. He quickly dies in the water and does not move, and it is precisely because of the stirring and the creation of vibrations that attract the fish, and add a living component. With ice cream moth the same story – it only creates a smell, but does not stir. A great ingredient for prikormki – this is the usual earthworms. They live in the water for a long time, crawling along the bottom, and rustling during crawling, attracting bream. Cut them into pieces are not worth it, it is a whole worm that lives longer and is more attractive for fish.
An alternative to the dead crank in the bait – fish food “Daphnia dry.” You can buy it in the bird market at an affordable price. It is better to purchase in a large package. Fish and bone meal are also well suited as an additive. Instead of pellets as a large component, you can use dog food or feed for pigs. It has almost the same composition and structure as pellets, but costs much less.
Aromatics
In feeder fishing it is widely used to add aromatic substances to bait and to flavor them with aromatics. Usually used for this flavoring, which are sold in fishing stores. Most of them are synthetic, and only some, such as molasses, are of natural origin. However, both natural and less natural fish attract equally well.
When adding flavors need not to overdo it. For example, adding them in large quantities to the prikormku for starter zakorma not worth it. And in general, probably, it is not necessary to add aromatics to the starter fodder. But you need to add a little bit to the working trough, especially when weakening the bite. So the fish will find it faster in the water and come out on a hook with a nozzle. June water is warm enough to bait it worked well.
Nozzles can also be flavored with aromatics. At the same time also need to comply with the measure. It is best for her to use the highest quality and proven smells, and they should differ slightly from others, which are used for bait. So the fish can be distinguished at the bottom among other objects and eaten with a fishing hook.
For bream there are some smells that attract him. For most reservoirs it is ginger, cinnamon, cloves, some fruit smells. Dill does not frighten him, but is able to attract a lot of roach, for which it is almost the best flavor. Vanilla also works well for bream, as well as biscuit and caramel smells. In general, any “pastry” smells are suitable for bream, and you can use them without fear. But with the smell of some herbs, such as anise or celery, you should be careful.
It is also worth paying attention not only to the name and feeling of the person from the smell, but also to the manufacturer’s company, packaging and type. If you happen to find an effective flavoring type “caramel” for catching bream, not the fact that another “caramel” is also suitable. The fact that the fish perceives the smell and color is much thinner than people. And the notes that we do not catch at all will have a strong influence on her.
Nozzles
One of the most effective baits for catching bream in June is a common dung worm. It falls in abundance into the water during the spring flood, and the bream is attached to it well and for a long time. The dung worm also has a strong natural smell that attracts bream.
Unfortunately, manure worms have one big drawback – they are also loved by other fish. Not always want, instead of bream on a hook perch and ruffs. Therefore, usually the worm is used in a vegetable-packed sandwich, or only vegetable is used. From vegetable nozzles, priority should be given to those made on the basis of semolina: mastyrka, semolina porridge, in some cases – pasta. If you want to cut off the bites of trifles, the nozzle should be large and simply do not fit into her mouth. Pasta best cope with this task.
Good results are shown by alternative animals of a nozzle: larva of the May beetle, dragonfly, caddis. Unfortunately, finding them on the beach or in the garden does not always have time, and they are not on sale in the fishing store. Unlike a worm, bloodworms and moldy worm. The last two nozzles, by the way, are not very suitable for bream for the same reason – they do not often take bream, but rather trifles, rather than giving the bream a chance to come.
An excellent nozzle to catch a trophy bream on a pond is a large worm. Vypolzki, or shura, are in sufficient quantities during plowing or digging the garden in the spring. Fisherman should stock up on them in large quantities then. In June, you can still find creeps at night, passing with a flashlight on the beds. But in the summer heat, almost all of them go to a considerable depth, where it is simply impossible to find them.
Shuras are longer – up to 40 cm and thicker. Usually a single hook is not enough to put it in such a way that the worm does not crawl. Or you have to use too large somovy hook, which will immediately alert the bream. Therefore, use a tackle of two hooks, fixed between a small wire. This tackle allows you to reliably impose vypolzka. Pulling off a crawler tackle is difficult, and the bream is much less wary about wireworms than a catfish hook, and will gladly accept a worm on a hook from an angler.
